6/21/2023 0 Comments Artcam pro 7 to mach3 gcodeJust thought there is the drilling cycle so that could be used to drill the deep hole first.Īny ideas would be appreciated as I'm no Gcode wizard, I just get by using CAM and the supplied wizards with a little hand coding to fill in the gaps sometimes. After setting up my machine and getting used to how it operates with Mach 3 software I quickly realised they were not necessary. Is there a pocketing canned cycle in Mach that could be used so he's met the canned cycle criteria? When I ordered my Taig cnc desktop mill I added some limit switches to my order thinking I would need to use them as homing switches. Carveco Distributor USA Legacy ArtCAM Training & Support. you will find it is not recommended to run other programs on the cnc control computer, it should be a bare bones system for the cnc. The project is to do one side of a cube with circular pockets getting smaller and deeper, this would normally be repeated on all 6 sides and also have holes in the corners. One computer for nc studio controller and one for design with Artcam and other necessary programs. I've also already done the code using the NFS wizard to show him how I'd do it on my mill but this may not satisfy the assignment criteria (took all of 2 minutes) He's not written it yet but it's meant to make use of the canned cycles, now I suspect that these will not be compatible. My son has a project from Collage that he can do on my mill running Mach3 because they only have the one Haas CNC mill and the whole class has to write and run their own code, because it's meant to be written and run on the Haas I was wondering if it would run on Mach3.
0 Comments
Leave a Reply. |